Whitening gel application

How do I use the teeth whitening device & treatment?

Use the teeth whitening treatment 10 minutes per day for 10 days in a row.

Make sure all items are inside kit:

• 20 gel vials (2 per day for 10 days)
• 1 teeth whitening device and recharger tray
• 1 recharger cord

STEP 1: Preparing the Device - The device must be fully charged before use

Put the device inside recharger tray and close the tray. Make sure that the tray is securely closed or device won’t charge. Plug the recharger cord into the recharger tray and outlet to charge. Let the device charge overnight or a minimum of 4 hours before each usage.The power button will flash green while the device is charging. It’ll illuminate steady green when the device is fully charged. Once charged, remove the device from the recharger tray. Device must be clean and dry before use. It can be cleaned with lukewarm water and dried with a soft towel. The device should charge for 4 hours between uses or until the charging light stops flashing.

Light Indicators:

Flashing Green: Charging
Solid Green: Fully Charged, ready for use
No light: Not charging/not attached to a power source

STEP 2: Dispensing Gel into the Device

The device contains an upper and lower part. You will use 1 gel tube for each part of the mouthpiece.To open the gel tube, twist off the safety seal at the tip. Dispense the gel from left to right into the bottom corner along the bottom edge of the panel of the mouthpiece making sure it will seep into your teeth when you bite down. Squeeze as much of the gel as possible from tube 1 into the top tray of the device. Turn the device over (the gel is thick and will not leak when turned upside down). Open the tube. Dispense the gel like you did on the top tray. Squeeze as much of the gel as possible from tube 2 into the bottom tray of the device.

STEP 3: Wearing the Device

Press the power button to turn the device on. It’ll illuminate blue when it’s on. Position it so the power button is facing upwards and insert into your mouth. Make sure upper and lower teeth are seated completely in the device.The device will beep halfway through the treatment. Keep the device in your mouth for full 10 minute treatment. The device will beep 5 minutes into treatment to indicate the halfway mark. Don’t take it off. Once the treatment is over, the device will beep twice and the power button will automatically turn off. Remove device from mouth. Rinse mouth thoroughly with water. For best results, avoid eating or drinking for 30 minutes.

STEP 4: Cleaning the Device

Rinse the device with warm water (it’s waterproof)! If needed, use a soft toothbrush or cotton swab to remove any remaining gel. Make sure the device is clean and dry before returning to the recharger tray. Recharge the device overnight for the next day’s usage.Repeat steps through 1 to 4 once a day for 10 days in a row.

For best results, avoid eating and drinking for 30 minutes afterwards.

How do I turn the teeth whitening device on/off?

Simply press the power button to turn the Teeth Whitening Device on. You’ll know it’s on when the power button shines blue. After 5 minutes the device will beep to let you know it’s half way thru. After 10 minutes of treatment, the Teeth Whitening Device will beep and automatically turn off to signal that your treatment is complete.

How do I apply/use the teeth whitening serums?

How many vials of teeth whitening serum do I use?

The 10 day treatment includes 20 vials of Teeth Whitening Serum. Use two vials per day—one vial for top teeth and one vial for bottom teeth—for 10 days in a row.